Car LED 3D Logo Laser Projector Lights,Custom Logo Available!

This LED Lights can be automaticlly on when car doors open.

Outpower:3W x2pcs LED projectors

Voltage:12V/24V

Working Temp:-40 degrees~ 105 degrees

Material:Aluminium alloy casing

Life span:50,000 hours

Length:60mm,Diameter:22mm

Waterproof:IP65

Installation:

This LED lights can be installed at the bottom of the door flame and make sure the Len vertical with the ground ;

1.Pull down the inside door board first. Mark the suitable location for drilling a hole.

2.Drill the hole on the door board with our borer .

3.Inset the product from the bottom of car door ,then arrange the power cord.

4.Install the nut through the power cord upon the hole inside; Tighten the nut;

5.Connect the power cord according to the installation guide;

6.Adjust the lamp projection to the suitable place with wrench tool.

7.Reinstall the inside door board,then check the final effect.